Blog

This is one of the simplest wiring tasks in a hotel guest room, and one of the most commonly done in a way that causes problems eighteen months later. The connection itself takes minutes. The decision about how to route the chain is what determines whether a single loose terminal takes out one panel or […]

The objection to smart room control in an operating hotel is almost never the product cost. It is the closure. Chasing walls to run new lighting circuits means the floor comes out of service, and for a property running at reasonable occupancy, lost room nights cost more than the control system. There is a way

This decision is made early, usually before the first room is wired, and it is expensive to reverse. Once the conduit is in the wall and the cable is pulled, changing from one method to the other means re-wiring every room. The choice is not about which switch is better. Both work. It is about

The twin room is where copied details cause the most trouble. The entrance and bathroom provisions are identical to a king room, so it is tempting to reuse the whole detail. But the bedside arrangement is different, and the socket arrangement is different in the opposite direction. This is the schedule we mark on a

This is the layout we mark on a king room floor plan before the electrical drawings are issued for construction. It is written as a schedule rather than an explanation, so it can be checked against a drawing directly. The king room differs from the twin room in two specific ways — panel positions and

Motorised curtains are the guest room function that most often generates a service call in the first year. Not because the motors are unreliable, but because the connection between motor and control system is made in a hurry at the end of a fit-out, usually after the curtain track is already installed and access is

These three devices sit within half a metre of each other at the guest room entrance, and together they handle the first and last impression of the room. They are also the easiest devices in the room to wire, which is why they are often given the least attention on the drawing. All three connect

Ask three people on a hotel project what the RCU does and you may get three answers. To the electrical contractor it is a box in the ceiling void. To the hotel operations manager it is whatever makes the lights work. To the guest it is invisible. In practice, the room control unit is the

Most guest complaints about room lighting are not product failures. They are layout decisions made months earlier on a drawing. A guest walks into a dark room at 11 PM and gropes along the wall for the card slot. Another lies in bed and has to sit up to reach the reading light, because that

Walk into most hotel rooms built before 2015 and there is a telephone on the nightstand that almost nobody picks up. Guests use their own mobile. The handset stays there because the room specification has always included one, and because there was no alternative way to reach the front desk from inside the room. There